The DSC server can be a managed storage server or a VM. This procedure only applies to a managed storage server recovery.
The following procedure installs SLES package and other updates. It does not install DSA software.
- Start PUT.
- In the main screen, select Install/Upgrade Software and click Next.
- In the Configuration Mode screen, select Typical and click Next.
- In Network Subnet Selection, select 127.0.0.0 (LOOPBACK) and click Next.
- In Select Nodes, verify that the node name in the Selected list is localhost (LINUX), and click Next. If a warning message appears, click Ignore.
- In the System Information Warning screen, click Next.
- If the System Check Found Problems screen appears, verify that there are no issues that need attention (or correct any issues that need correcting), and click Ignore.
- Accept the default selection in the Select Spool Area for Linux Nodes screen and click Next.
- In the Enter Source for New Packages screen, enter or select the path /var/opt/teradata/ccnumber/pkgs and click Next.
- In the Media Source Confirmation screen, enter or select the source for the new package and click Next.
-
In the Group Nodes screen, verify that the node displayed in the right panel has the following settings and click Next:
- System - System0
- Group - Group0
- Node Type - DSADSC
-
In the Select Packages screen, select and add the software packages:
- All packages except DSC, ClientHandler, BARPortlets, and BARCmdline
- Accept the default options for the remaining steps.