The apiconfig.xml file is available on all servers.
- To verify that IPv6 is enabled, contact the server using ping6.
-
Identify the IPv6 address and the interface.
-
On a non-Windows server, type ifconfig.
The output includes the information you need as shown in the following example:
eth3:Ethernet  HWaddr 00:50:56:86:0B:77 inet6 addr: fe80::250:56ff:fe86:167e Scope:Link
Where eth3 is the interface and fe80::250:56ff:fe86:167e is the IPv6 address. -
On a Windows server, type ipconfig.
The output includes the information you need as shown in the following example:
Ethernet adapter Local Area Connection 2: IP Address............: fe80::250:56ff:fe86:167e
Where 2 is the interface and fe80::250:56ff:fe86:167e is the IPv6 address.
-
On a non-Windows server, type ifconfig.
The output includes the information you need as shown in the following example:
-
Specify the IPv6 address in the apiconfig.xml file by adding the following:
<receiver> <host>IPv6 Address%Interface</host> <port>61616</port> </receiver>
For example:<receiver> <host>fe80::250:56ff:fe86:167e%eth3</host> <port>61616</port> </receiver>
The default port number for the Active MQ service is 61616.