The jobs required for the installation of Teradata® Tools and Utilities are located in dbcpfx.GTW.PROCLIB. They must be customized to conform to installation standards. Use the following procedure to complete the customization.
- Make the necessary changes to the customization dictionary, member #INSTCD, in dbcpfx.GTW.PROCLIB. Any entries pertaining to products that will not be installed may be skipped. It is not necessary to delete entries not applicable to your installation.
- Create a member of dbcpfx.GTW.PROCLIB named JOBCARD which contains a JOB job control statement. The contents of this member will be inserted at the beginning of each of the installation jobs during the customization procedure.A Sample Jobcard (#JOBCARD) is included in the distributed GTW.PROCLIB which also contains a RESTART statement. RESTART can be used to restart the #INSTALL job at the correct step or sub-step if an error is encountered during the installation process. If you choose to use the #INSTALL job, update the #JOBCARD member to conform with the information for your data center and rename the member to JOBCARD.
- Type the following command to run the customization procedure:tso exec ’dbcpfx.GTW.proclib(#instxec)’ exec
- Review all of the JCL provided for compliance with the conventions and standards used at your site.Each time the customization procedure (#INSTXEC) is run, the entries from the customization dictionary are applied to a set of unmodified installation JCL statements so the procedure may be run as many times as necessary.