Configure DSC to Run Internally and Externally | Teradata Data Mover - 17.05 - Configuring DSC to Run on the Data Mover Server and Externally - Teradata Data Mover

Teradata® Data Mover Installation, Configuration, and Upgrade Guide for Customers

prodname
Teradata Data Mover
vrm_release
17.05
created_date
October 2020
category
Administration
Configuration
Installation
featnum
B035-4102-090K
Refer to the following configuration steps when running DSA on both the Data Mover server and on an external server. To run DSA on the Data Mover server, you must have Data Mover 16.20 or later installed.
  1. For source and target TPA nodes with existing BAR NC ClientHandler software, edit the /etc/opt/teradata/dsa/clienthandler.properties and append the Data Mover host to broker.list as in the following example:
    broker.list=153.64.24.162:61616,153.64.24.164:61616
  2. Register all source and target systems with DSC and restart DSMAIN.
  3. Install and configure BAR NC on new source or target TPA nodes.
  4. Configuring the Logical Netmask for ClientHandler.