Type C Power: Appliance Cabinet Two-Cord 60A Three-Phase Delta with Watertight Power Plugs and Receptacles - Appliance for Hadoop

Appliance for Hadoop 6 Platform Product and Site Preparation Guide
Product
Appliance for Hadoop
Published
February 2018
Language
English (United States)
Last Update
2018-04-13
dita:mapPath
cwt1471885643827.ditamap
dita:ditavalPath
hadoop6.ditaval.ditaval
dita:id
ikf1471650918043
Product Category
Hardware

This plug type is for Canada, Columbia, El Salvador, Japan, Mexico, Nicaragua, Panama, South Korea, Taiwan, United States, and Venezuela. a

Unit
  • Appliance for Hadoop 6 Cabinet
Power Type

60A three-phase Delta power
Nameplate Rating b c
  • 48A per cord
  • 200-240 V~, 3+PE

Expected Utility Power Sources

(Provided by Site)

  • Three-phase Wye with a line-to-neutral voltage typically 120V or 127V and a line-to-line voltage of 200V to 240V.
  • Alternate expected power source (Japan): Delta power source 200V to 240V on each side.
With either of these two utility power sources, each of the 4-pin power plugs will connect to all three lines and also to safety ground. With this power solution the power plug will not have a neutral connection.

Power Plug and Number of Cords

(Supplied with Product)

IEC 60309 CEE17, pin and sleeve, 60A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP67 watertight plug

(Walther Electric brand is shown below. Actual brand supplied with cabinet may vary.)



Two AC feeder box cords per cabinet, top or bottom egress.

The minimum bend radius limit for the power cord is 16.5 cm (6.5in.). Do not bend the power cord tighter than this limit.

AC Feeder Box Power Cord Connections to Site Power

(For Redundancy)

The power cord on the left AC feeder box in the cabinet connects to one site power source. The power cord on the right AC feeder box in the cabinet connects to the second site power source.

Power Receptacle or Connector

and

Circuit Breakers

(Provided by Site)

IEC 60309 CEE17, pin and sleeve, 60A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP67 watertight receptacle or connector



Example receptacles (similar products are available from other companies):
  • Hubbell HBL460R9W
  • Leviton 460R9W
  • Scame Electrical Solutions SCM460R9W (shown above)
  • Walther Electric 469409


Example connectors for use with cordage (similar products are available from other companies):
  • Hubbell HBL460C9W
  • Leviton 460C9W
  • Russellstoll ABB460C9W
  • Scame Electrical Solutions SCM460C9W
  • Walther Electric 369409 (shown above)
Example connector for use with 1-inch NPT fitting for connection to conduit: d
  • Hubbell HBL460C9W combined with Hubbell SAC100
Example connector for use with 1 ¼-inch NPT fitting for connection to conduit: d
  • Walther Electric PG36-125 combined with Walther Electric 369409

Customer to supply two receptacles or connectors per cabinet. e

One three-pole site circuit breaker required for each power cord; customer must provide required site circuit breakers.

Each AC feeder box on separate power source connection.

a Bahrain, Brazil, Lebanon, Philippines, and Saudi Arabia require discussions with the site team to determine the appropriate power feature for the specific site.

b Do not use this table to determine power consumption, to estimate current draw, or to estimate heat generation. For these parameters, see Site Environmental Planning. Nameplate ratings are a statement of product certification.

c Frequency rating is 50 or 60 Hz for all products.

d Conduit Adapters do not connect to the ground terminal of the connector. Consult your local code grounding requirements before using adapters.

e Customer can obtain connectors from any source. Connectors are available from Teradata by ordering kit 2021-K902. One kit is required per appliance cabinet.